Randy Smith's LC-1 Installation.

Randy Smith's LC-1 WBO2 installation with the pig tails cut to length and very neat placement of the LED's and calibration switches.
The re-cal button and LED do not have to be hard mounted. A soft mount inside the right side cover make it easier for most people to install them. Here is the picture showing this soft mount. Wires were connected, soldered and sealed with heat shrink. They were tie wrapped in place and covered with a piece of inexpensive wire loom. Other than that, everything was pretty simple. Everything was cut to length and tucked. The serial cables put into the space where the ground lugs are behind the tank.